Cotek SK200 Series Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Netzteile und Wechselrichter Cotek SK200 Series herunter. Cotek SK200 Series User`s manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 19
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
SK120,SK200,SK350 Series
Pure Sine Wave Inverter
User’s Manual
Seitenansicht 0
1 2 3 4 5 6 ... 18 19

Inhaltsverzeichnis

Seite 1 - User’s Manual

SK120,SK200,SK350 Series Pure Sine Wave Inverter User’s Manual

Seite 2 - Table of contents

3. Instructions This power inverter series is a the member of the most advanced line of mobile AC power systems available. To get the most out of t

Seite 3

3-1-3. Status:Display Power & Fault Status Green LED LED Signal Status Solid Power OK Red LED LED Signal Status Blink (Fast) OVP Bl

Seite 4 - 2. Features

3-2. Rear Panel Operation: REMOTE PORTGNDENBENBDC INPUTPOWERREMO.OFFONNEG (-)CHASSISGROUNDPOS(+) REMOTE PORTCHASSISGROUNDREMO.DC INPUTENBENBGNDP

Seite 5 - 2-1. Electrical Performance

NOTE: Only one of control mode can be presented. When operating. 3-2-2. DC Input Terminals: Conn

Seite 6

3-3. Protections Features: DC Input (VDC) Over Temperature ProtectionOver Voltage Under Voltage INTERIOR Model Shut-down Restart Under Voltage A

Seite 7

3-4-6. Close to batteries – Avoid excessive cable lengths but do not install the Inverter in the same compartment as batteries. Use the recommende

Seite 8

3-6. AC Safety Grounding: The AC output ground wire should go to the grounding point for your loads ( for example, a distribution panel ground bus

Seite 9

Ground Fault Circuit Interrupters (GFCI): Installations in Recreational Vehicles (for North American approvals) will require GFCI protection of all

Seite 10 - 3. Instructions

4. Troubleshooting guide: Problems and Symptoms Possible Cause Solutions “No AC Power Output” STATUS illuminates the red LED a. Blinking fas

Seite 11 - CIGARET STRIPPED WIRE

5. Maintenance: Very little maintenance is required to keep your inverter operating properly. You should clean the exterior of the unit periodicall

Seite 12

Table of contents 1. Important Safety Information.……………………………………………… 1-1 General Safety Precautions…………………………………………… 1-2 Precautions When Workin

Seite 13

1. Important Safety Information 1-1. General Safety Precautions 1-1-1. Do not expose the Inverter to rain, snow, spray, bilge or dust. To reduce r

Seite 14

2. Features Pure sine wave output (THD < 3%) Output frequency:50 / 60Hz switch selections Input & output completely isolated design High

Seite 15

2-1. Electrical Performance Specification Model No. Item SK120-112 SK120-124 SK120-148 SK120-212 SK120-224 SK120-248Continuous Outp

Seite 16

Specification Model No. Item SK200-112 SK200-124 SK200-148 SK200-212 SK200-224 SK200-248Continuous Output Power 200W Maximum Output Power 220W Sur

Seite 17

Specification Model No. Item SK350-112 SK350-124 SK350-148 SK350-212 SK350-224 SK350-248Continuous Output Power 350W Maximum Output Power 385W Sur

Seite 18 - 4. Troubleshooting guide:

2-2. Mechanical Drawing of Socket (Power Claw PP75) REMOTE PORTENBCHASSISGROUNDONOFFREMO.POWERENBGNDPOS(+)NEG (-)DC INPUTPure Sine Wave Inverter PU

Seite 19 - 6. Warranty:

2-3. Mechanical Drawing of Strip Wire Type REMOTE PORTOFFONPOWERGNDENBENBDC INPUTREMO.CHASSISGROUNDPure Sine Wave Inverter PURE SINE WAVE INVER

Kommentare zu diesen Handbüchern

Keine Kommentare