Cotek S600 Series Bedienungsanleitung

S600,S600R Series Pure Sine Wave Inverter User’s Manual

3-2-2. Ventilation Shaft： Be sure to keep it a distance (at least 1 inch) form surrounding things. 3-2-3. Input terminals： Connect the input terminal

3-3. Installation： The power inverter should be installed in an environment that meets the following requirements： 3-3-1. Dry – Do not allow water to

3-4. Quick hook – up and testing： For a quick hook – up of the power inverter to check its performance before going ahead with installation, please f

3-4-3. Before proceeding further, carefully check that cable you have connected does tie negative terminal of inverter to the negative output power s

3-5. AC Safety Grounding： During the AC wiring installation, AC input and output ground wires are connected to the inverter. The AC input ground w

Ground Fault Circuit Interrupters (GFCI)： Installations in Recreational Vehicles (for North American approvals) will require GFCI protection of all b

Increasing DC cable size helps improve the situation. Cotek recommends the following cables for optimum inverter performance. (apply both 120V and 23

3-7. Inverter Operation： To operate the power inverter, use the ON / OFF switch on the Front panel to turn the power on. Then the power inverter i

4. Troubleshooting： WARNING! Do not open or disassemble the S600 Inverter. Attempting to service the unit yourself may cause an electrical shock or f

5. Maintenance： Very little maintenance is required to keep your inverter operating properly. You should clean the exterior of the unit periodically

Table of contents 1. Important Safety Information.……………………………………………… 1 1-1 General Safety Precautions…………………………………………… 1 1-2 Batteries Precautions…

7-1. CE (LVD EN60950) Declaration of Conformity： 18

7-2. FCC (Class B) Declaration of Conformity：19

7-3. e-mark (e13 020866) Declaration of Conformity：20

7-3. e-mark (e13 020866) Declaration of Conformity： 21

7-4. UL (UL458) Notice of Completion22

1. Important Safety Information WARNING! Before installing and using the Inverter, you need to read Following safety information carefully. 1-1.

2. Features Pure sine wave output (THD < 3%) Output frequency：50 / 60Hz switch selections Input & output fully isolated design High effi

2-2. Electrical Performance Specification Model No. Item S600-112 S600-124 S600-148 S600-212 S600-224 S600-248Continuous Output Power 600W Maximu

2-3. Mechanical Drawing 4

3. Instructions This power inverter series is one of the most advanced line of mobile AC power systems. To get the most effective power inverter, it

3-1-4. Load Level：Display AC Load Watts LED Status Load Condition Dark 0 ~ 30W Green 30W ~ 200W Orange 200W ~ 450W Red 450W ~ 580W Red Blink Ov

3-2. Rear Panel Operation： POS(+)DC INPUTWARNING: REVERSE POLARITY WILL DAMAGE UNITCHASSISGROUNDNEG(-) WARNING: REVERSE POLARITY WI